Orochi V2 Bluetooth unable to wake computer

I've tested my Orochi V2 in several several conditions, on both the wireless usb and bluetooth. With the same windows configured settings for the mouse, I've noticed that -

On wireless:
- Computer sleeping, mouse not sleeping, click/move - immediate wake
- Computer sleeping, mouse sleeping, click/move - almost immediate wake (like a .2 sec delay)
- Computer not sleeping, mouse not sleeping, click/move - immediate response
- Computer not sleeping, mouse sleeping, click/move - immediate response

I have no problems with the Orochi on wireless, but the bluetooth results worry me.

On bluetooth:
- Computer not sleeping, mouse sleeping, click/move - mouse slowly amplifies and fades a blue light until connected, which takes about ~10 seconds. Light then completely disappears and there is response
- Computer sleeping, mouse not sleeping, click/move - No response (mouse is in the amp/fade blue light at the point of computer sleep
- Computer sleeping, mouse sleeping, click/move - No response (mouse does amp/fade blue light, but nothing happens. Even if I turn my computer after I move my mouse, still takes ~10 seconds from the initial movement of my mouse for it to connect to my computer)

This is a bit annoying, especially when both my computer and the mouse is sleeping at the same time. It essentially guarantees a >10 second wait before I can really use my computer when the orochi is connected to bluetooth.

I've tried troubleshooting this with other threads. In the Device Manager, I checked "Allow this device to wake the computer" for the Orochi under "Keyboards" and "Mice and other pointing devices," but it didn't change the bluetooth results.

* If it matters, I'm running on a B550 motherboard with an AX200 wifi card on Windows 10. I've also updated to the latest mouse firmware with the updater.

My question is: Is this kind of bluetooth behavior (10 sec delay, unable to wake computer) expected? If not, what next troubleshooting steps should I take?