Razer Basilisk X Hyperspeed Bluetooth Not Showing Up | Razer Insider

Razer Basilisk X Hyperspeed Bluetooth Not Showing Up

  • 2 September 2021
  • 3 replies
  • 99 views

Hey all,
I just got a new laptop- its the lenovo legion 15, and I'm stupid and didn't realize that it didn't have the right port to put the chip for the razer basilisk x hyperspeed mouse in. So unless there's some extender cord, my only choice is using the bluetooth option. And for some reason it doesn't even show up on the bluetooth list when i try to connect. I don't think it's the mouse problem but I might be wrong, as it can connect to my old computer just fine via bluetooth, I already disconnected it from that one and tried again but still no luck.

Any help would be appreciated, thanks!

This topic has been closed for comments

3 Replies

Userlevel 7
Badge
You must enable pairing mode on your Basilisk X Hyperspeed in BT mode.
Just turn it on in BT mode and hold both side buttons MB4 & MB5 and DPI cycle button for 3 seconds. Then your mouse will be detected by computer.

Look at the guide - site 10: https://dl.razerzone.com/master-guides/RazerSynapse3/BASILISKXHYPERSPEED-00000131-en.pdf
If Razer Synapse fails to detect your Razer device, it could be either due to a software or hardware issue. Another reason is your Razer device may not be supported by the version of Synapse you are using.

check mygiftcardsite balance
I did, and it goes into it's BT pairing mode by blinking two times a blue light. But it still doesn't show up.

Is there any sort of extension cord to put the 2.4 chip in? Or this may be asking too much, but does anyone have recommendations of mice $50~ that hasa 3.2 chip?