Worried about V3 Pro joints breaking - preventive steps? | Razer Insider
Skip to main content
Question

Worried about V3 Pro joints breaking - preventive steps?

  • Jul 31, 2025 9:58 AM UTC
  • 3 replies
  • 932 views

Recently bought the Razer Blackshark V3 Pro. Previously had the V2 which spontaneously fell apart at its hinges (which I can see was a widespread issue).

I like other aspects of this headset and having returned various other models from other manufacturers due to similar defects, I'm kind of at the point where I want to see if I can just secure it myself.

I say this because the joints look very similar to the V2 and I haven't got a lot of faith in them, albeit the lower sections do swivel now which hopefully reduces the chance of breakage.

Any ideas on how to approach this? I thought about getting some electrical tape and just running a few layers over the joints to reinforce them.

Alternatively if a Razer rep can reassure me that this fault has been specifically and reliably addressed in the V3 that would be much appreciated.
 

3 Replies

IVORYtechVividOrange220

Bro, it’s razer. They’ll never admit there was an issue with the earlier blacksharks. 
But oh it was, the plastics were terrible. Im on my second pair, and both joints are broken on these too. I fixed them with some zipties. Not buying another pair.

One could hope razer learnt something, and actually reinforced the joints.

I loved these headsets cuz they were great for my planet sized head. if they only stopped breaking...
 


  • Insider Mini
  • Oct 29, 2026 2:32 PM UTC

I solved my problem by doing this. That is a 2023 V2 Pro, and one of the hinges fell apart while the other was still intact. I wrapped it tightly with black sewing thread, about 5–6 months has passed after I did that, still haven’t had any issues. So give this a try, whether the hinge has already broken or not, it should solve your problem.

 


  • Insider Mini
  • Oct 31, 2026 8:58 AM UTC

Good question. A few things that help with any headset hinge: store it on a stand instead of tossing it flat, so the joints are not sitting under sideways pressure. Wipe down the headband area now and then, since sweat and dust work their way into moving parts over time. When you take them off, pull from both earcups instead of yanking one side, which twists the hinges. And try not to leave them in heat like a car dashboard, since heat makes plastics brittle faster. A cheap knit headband cover also spreads the pressure a bit. None of that fixes a weak design, but it buys time.