Razer viper 8khz. Cursor shakes after firmware update | Razer Insider

Razer viper 8khz. Cursor shakes after firmware update

  • 15 September 2021
  • 5 replies
  • 108 views
B
Userlevel 1
Updated the firmware to Viper 8KHz_Mouse_FirmwareUpdater_v1.02.00_r1. I set the dpi to 20,000, the cursor began to shake, the same thing happens less often at a lower dpi. On the usual firmware Viper 8KHz_Mouse_FirmwareUpdater_v1.00.06 everything was ok
This topic has been closed for comments

5 Replies

T
Can confirm: The same firmware update introduced the same 'cursor shake' issue with my Razer Viper 8KHz mouse as well.

More noticeable at high DPI values, less noticeable below 2000 DPI (but still there, just very slight).
B
Userlevel 1
Taltharius
Can confirm: The same firmware update introduced the same 'cursor shake' issue with my Razer Viper 8KHz mouse as well.

More noticeable at high DPI values, less noticeable below 2000 DPI (but still there, just very slight).


In Synapse 3, click on your profile and there for feedback. Write a letter about the problem with the cursor after the firmware update. The more such letters from people, the faster they will pay attention to the problem.
M
I have this problem as well 1600 dpi it's still there.
D
I also have the same problem, I updated the firmware must be the cause of the problem

It's been a few months, have you solved the problem?
Razer.Speedcr0ss
Userlevel 7
Hey everyone! Please submit feedback through the Razer Synapse 3.0 main screens under the feedback section or submit a case through this link so our Support Team can assist you via email. Feel free to send me a PM too.

*Thread is now locked.
CookiesCookie settings