Razer Deathadder V2 Lightning resets after closing Synapse | Razer Insider

Razer Deathadder V2 Lightning resets after closing Synapse


As I said when I close Razer Synapse Mouse Lightning resets to deafult spectrum cycling.

Did anyone have the same problem? How to fix it?

This topic has been closed for comments

5 Replies

Userlevel 7
Badge
xNekson
As I said when I close Razer Synapse Mouse Lightning resets to deafult spectrum cycling.

Did anyone have the same problem? How to fix it?

Keep your Synapse open. Lightning effects are not stored in mouse memory.
Ok, Thank You.
I have bought two Deathadder V2 mice for the following reason (taken from Razers own site)

"ADVANCED ON-BOARD MEMORY
Save and store up to 5 profile configurations to the on-board memory and bring your settings anywhere—so you’re always ready to compete with your preferred controls."

As per the OP the mouse IS NOT STORING PROFILES ON ITS OWN MEMORY, hence the button underneath is useless when you plug it into another PC without Razer software running !!!

WE HAVE BEEN MISLED !!
Every time I turn on my PC, my new Deathadder v2 uses the deafult spectrum cycling instead of the profile I was last using.
How can this be? My old Deathadder v1 didn't need any software running to use the correct light profile.
Any one knows if the Elite suffers from the same problem?
Is the Essential basically a v1?
Thanks in advance.
Bump..... Firmware updates ARE available/possible. We have two Deathadder V2 mice, one had a firmware update !. SO WHERE IS ONE TO STORE BASIC COLOUR PROFILES ON MOUSE RAZER ????