Can't change DPI on Reazer Deathadder elite

Hello everyone, I have a problem with my mouse, I can't change the DPI sensitivity. The buttons works all fine and I can see on Synapse 3 that they change the settings, but in reality it doesn't work. I tried to uninstall and reinstall synapse 3 with no results, I even try to update the firmware (version 1.06) of the mouse with the dedicated link I found (firmware), but even if I close all synapse programs (I even tried with it uninstalled) it doesn't update the drive and remain on version 1.02.1. My mouse isn't in warranty anymore, so I can't ask for technical support from the razer staff and the only way is via the forum. I think that could be a cloud problem, with the data corrupted in the cloud, I don't found any way to go offline on synapse 3 or remove all cloud's data. Someone can help me with this problem? 1.01 EDIT : I tried to install synapse 2 but the issue still remain, I even try to update the driver to version 1.05 but it gave me the error --> "parameter cannot be null. Parameter name: value" 1.02 EDIT : I tried from another PC that never got this mouse plugged in, there are still the same issue with the firmware update, I even tried to log into synapse3 as a guest from this PC, but still the DPI remain locked only on one sensitivity and change it does nothing. 1.03 EDIT : I follow this guide on the forum for a clean reinstallation and the "manual change of DPI", still doesn't work even in guest mode /my-razer-deathadder-elite-keeps-resetting-the-dpi-options-and-the-lighting.74869/#post-757531 1.04 EDIT : Every system in my computer is updated, from win10 to nvidia drivers. I don't think is a cloud issue because even in guest mode it doesn't work properly. The problem appeared when I turned on the PC, the day before was all working fine. The mouse is still in good conditions, it doesn't have any hardware damage. I sincerely hope that there is a software solution to this problem, I don't want to create unecessary e-waste just because the mouse decide to set itself in default conditions and doesn't comunicate with synapse3. 1.05 EDIT : I restored the driver of the mouse and now I can change between the default sensitivity using the assigned buttons but only if synapse3 is closed (if I open it it stops on a default DPI in every config, even if the settings are 100/800/.....). Still I can't update the firmware, this time it doesn't even start the download, it stops after a couple of minute with the message: "Please reconnect your device!", ofc I don't plug it off during the process...