Hello,
I was using my Razer BlackShark v2 HyperSpeed headset this morning and suddenly it stopped working via the wireless mode.
The power button only works as play/pause when I use the cable, but it never powers the headset on.
Here is what I have already tried:
-
Hard reset (holding the power button 10–18 sec while connected with USB-C).
-
Firmware update through Synapse following the official Razer instructions.
The issue persists. Additional details:
-
After performing a hard reset, when I release the button the headset says “Power off.” Windows does not recognize the device at that point.
-
If I press the button again, it continues to say “Power off” every time. The only way to make Windows recognize the headset again is to disconnect and reconnect the USB-C cable.
-
Before updating the firmware on Synapse, the battery status was always stuck at 41% and never changed (from the moment the problem first appeared).
Seems the same issue karfakias had on
