Razer Ripsaw Pink display | Razer Insider
Skip to main content

Razer Ripsaw Pink display

  • 29 April 2020
  • 5 replies
  • 2 views

Pretty sure this isn’t a new topic jr I haven’t found a concrete fix for this anywhere on the net. I use streamlabs obs on my Alienware gaming laptop and have tried every little online fix suggested with no lucky. #HELP
Try switching your RGB Range on your Switch from Full to Limited or vice versa and see if the problem still persists.
Sorry I should have been more specific on gaming unit I play on an Xbox1.
Actually, it may still apply. Is your Xbox One Video Output set to "Standard?" If not, try standard.
Ok to humor you I ve changed the output and it didn’t help. So I thought maybe it’s just what I’m seeing on display and perhaps if I record it maybe the right colors as I ve seen some ppl say they had a miscolor on display but their recording was excellent. Result = pink display still persists. There is no solution to this problem anywhere on the internet and I ve yet to even see one given by Razer so I must assume this is a faulty card which only gets fixed by replacing the whole unit got bamboozled and have to figure out what my next move is as these are expensive.
JakeSusPecT
Ok to humor you I ve changed the output and it didn’t help. So I thought maybe it’s just what I’m seeing on display and perhaps if I record it maybe the right colors as I ve seen some ppl say they had a miscolor on display but their recording was excellent. Result = pink display still persists. There is no solution to this problem anywhere on the internet and I ve yet to even see one given by Razer so I must assume this is a faulty card which only gets fixed by replacing the whole unit got bamboozled and have to figure out what my next move is as these are expensive.


Please PM me the serial number so I can validate the model and look into other possible model-specific solutions. Also, would you mind sharing a short clip detailing your streaming setup? That would help us better understand your situation. *I'll be moving this to the Support board for visibility.