Wired Razer Wolverine v2 blinking twice but not working | Razer Insider
Skip to main content
Question

Wired Razer Wolverine v2 blinking twice but not working

  • September 17, 2023
  • 5 replies
  • 1962 views
SlateBluebussolo204

Wired Razer Wolverine v2 (not wireless), is blinking twice even when following the guide. It was working fine until for some reason it just stopped working. Pressing/holding the  Xbox button isn’t working, Windows device manager isn’t recognizing it. It just died for some reason. Is for a update, missing drivers?

5 Replies

Razer.Zionzedd
  • Razer.ZionzeddRazer Support
  • Razer Support
  • September 18, 2023

Hi @SlateBluebussolo204,

 

In the device manager under the other devices list, try to check if there’s a driver with an error next to it. If you see one, manually update the driver or uninstall it. PM me the serial number of your device so I can verify its model and check my resources for other model-specific steps to help you address your concern. Thanks!

K
  • kalashnik_100
  • Insider Mini
  • November 1, 2023

Hello Razer.Zionzedd ,

i have the same problem with my Razer Wolverine V2 | RZ06-0356. It was working fine but now it is not powering on (only LED bliks twice and then nothing happens) when i plug it into my Xbox SX. When i plug it in computer, sometimes get’s recognized, sometimes doesn't. When it is not recognized by computer, there is an exclamation mark on USB devices in device manager. When it is recognized it is shown as Xbox Gaming Device. However it is not working at all with Xbox SX, where it is generaly used. Please advice!

H

just try unplug and plug the fast connector 

IntrusiveTHOT
  • IntrusiveTHOT
  • Insider Mini
  • September 13, 2025

Im having this same issue. whenever i try to connect it to my phone, the light bar blinks 2 - 3 times (while my phone is showing pairing) then it will suddenly say “No Controller Found” inside maybe 6 seconds of the pairing attempt. the controllers chroma lights respond by lighting up but only after the pairing has failed (which is indicated on my phone). S/N:PM2249C10602207

It happened so suddenly while gaming that im afraid this might be the result of a hardware failure within the controller. it would save me a couple hundred $ if anyone can find a fix, or even a troubleshooting guide (preferably one that assumes you know how to set a VCR Clock. YES i turned it on and off again, etc)

RxpierMx
  • RxpierMx
  • Insider Mini
  • March 26, 2026

Hola, espero esté mensaje terminé traspasando la barrera del idioma:

tenía un razer wolverine V2 el cual de un dia para otro tambien fallo (parpadeaba 2 veces el Led, pero el control no encendia). Encontre que cuando hacia presion en el cable, concretamente en donde esta la desconexion rapida, el control daba señales de via e incluso si mantenia la presion, podia volver a usarlo…

Procedi a eliminar por completo la desconexion rapida, lo corte con unas tijeras, elimine la protección que cubre los 4 cables del control y los solde con un cautin y estaño directo a la entrada USB. 

El control quedo como el dia 1, 0 input lag, 0 drift y funcionando como debio de seguir funcionando el año pasado.

 

CookiesAccessibility statement