Razer Blade 17 (2022): location of video connector on motherboard? | Razer Insider
Skip to main content
Question

Razer Blade 17 (2022): location of video connector on motherboard?

S

I just opened up my Razer Blade 17 (2022) (Core i9-12900H / 3080 Ti) to install a second NVMe drive. After replacing the bottom case and powering the computer on again, I noticed the internal video had stopped working. I heard the Windows startup chime and was able to connect the laptop to an external display. The system is working normally, other than no longer being able to detect the internal display.

I suspect I inadvertently knocked the video cable loose from the motherboard, but none of Razer’s support documents and I’m having a hard time locating the port myself. Can someone please point me in the right direction so I can try reseating the cable?

Did this topic help you find an answer to your question?

2 Replies

directOrangePeelIVORY884

The video connector on the Razer Blade 17 (2022) motherboard is typically located near the edge of the board, close to where the display cable from the screen connects. It's often situated in the vicinity of other ports like USB, HDMI, or Thunderbolt ports. However, for precise details or troubleshooting, consulting the official Razer support resources or the motherboard manual would be the most accurate approach.

S
1 person likes this
  • S
    studiorx
S
  • studiorx
  • Author
  • Insider Mini
  • 1 reply
  • May 6, 2024

Looking at a couple of other disassembly videos on YouTube, I believe the cable I’m looking for is the EDP cable, which connects to the motherboard near the left hand speaker and immediately behind the second NVMe slot. Reseating this cable did not solve the issue, however. I’ll have to look into how to get inside the display assembly to check the other end of the cable.

Reply


CookiesCookie settings

Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings