And that it's in the correct place.
But....
I was sick and tired of removing my RAZER Arctech Pro case every time I wanted to get some good game time in.
I don't like the provided Junglecat Razer case; as it made my phone hot and also blocked my Chroma.
Plus, removing my nice expensive case to use that one seemed like a bad idea, to me, in general.
An added frustration was while out and about, I had to carry and keep track of an extra case, plus the piece that the Junglecat hooks into when not on the phone.
I'm just not that organized.
So, I decided to come up with an original solution, as there weren't any Junglecat mods available (to date) for 3D Printing.
After lots of measuring, failed prints, frustration, a huge learning curve and some eyeballing, this is what I came up with....
- Eliminates the need of the specific Junglecat case, and also the little piece between the controllers.
- Designed so that it slides onto sides of phone (with Arctech Pro case) and Junglecat attached. When you are done, or want a handheld controller, you simply take them off the phone, push them together and Voilà!
- Works best with the Arctech Pro case.
- Tudia case works also, but it might be a tad loose.
- Doesn't interfere with wireless charging, speakers or camera!
With the right information, It's theoretically possible for me to resize these for any phone!
https://www.thingiverse.com/thing:4105924
License: Creative Commons Attribution Non Commercial Licence