For some reason, I can't get output from it most of the time.
I only get synapse alerts that say the resolution is 0x0p @ 0fps.
Ideally it should say 1920x1080p @ 60fps
This topic has been closed for comments
@headpointRusset724 Is this still the case? If so, can you please send me a PM with a rough layout of your setup?
it is but I walked through it with support.
I'll write down the issue for anyone else having the problem.
When there's a monitor hooked up into the output of the razer ripsaw HD, it cannot capture any new input. Inputs load just fine whenever there isn't something plugged into the output, and continue to work after something is plugged into the output.
But whenever the input needs to start again, either from reconnecting the device to a laptop, or switching input devices, the capture cannot start without removing the output.
I'll write down the issue for anyone else having the problem.
When there's a monitor hooked up into the output of the razer ripsaw HD, it cannot capture any new input. Inputs load just fine whenever there isn't something plugged into the output, and continue to work after something is plugged into the output.
But whenever the input needs to start again, either from reconnecting the device to a laptop, or switching input devices, the capture cannot start without removing the output.
Sign up
Already have an account? Login
Log in with Razer ID to create new threads and earn badges.
LOG INEnter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.